by

Grilling Chicken On Cast Iron

Lodge Cast Iron makes some nice products.  They are quality cast iron, made in the USA, and sold at incredibly good prices.  Here is a link http://shop.lodgemfg.com/

I was at Walmart the other day to restock up on Corelle dinnerware (which is also great – they just don’t play nicely with a tile floor – and my numbers were dwindling).  I noticed this Cast Iron Grill pan:

81leZN8NLkL._SL1500_.jpg

I never saw the point in these before, but then again, never used one…  But the price was less than $20, so I figured I’d get one…. well I liked it so much I ended up with two :)

So far I’ve cooked Pork Chops and Chicken Tenderloins.  Here is a picture of the chicken from lunch today.  I must say, some of the best chicken I’ve ever eaten.  Perfectly seared, drizzled in salt, pepper, lemon, and butter, it was cooked completely but soooo tender and juicy.

20180410_143336.jpg

This deserves a longer post, but I’ll put the rundown here for reference:

  • Rinse tenderloins in sink and shake off excess water
  • Liberal amount of kosher salt and pepper
  • Get grill pan(s) screaming hot (starting to smoke) and lay the chicken on it for about 3-4 minutes until the underside has nice grill marks.
  • Turn chicken over, turn burner to LOW, and let other side also get grill marks (another 3 minutes or so).
  • Turn over every 1-2 minutes brushing butter on the freshly turned up side and drizzling fresh lemon juice on each side.  Continue this until internal temp reaches 165+ in the thickest part.
  • Let rest for 5 min in a pile on a plate.

Enjoy!

by

Southwestern Smoked Chicken And Corn

Another “experiment”…  Thanks again to Ezra, I had some fresh KC BBQ Rubbed Smoked Chicken Breast in the fridge.

Frozen, sweet white corn, in seasoned cast iron on high heat until perfectly done (stirring constantly).  Chopped up smoked chicken breast in.  A little Adobo (which is made from salt, pepper, garlic, spices) for seasoning and a few tablespoons of heavy whipping cream to meld it all together.

Served with On The Border corn chips and fresh salsa.  Mmmm.  It was outstanding.

20180326_232902.jpg

by

Smoked Chicken And Cheese Wrap

Being in the possession of some freshly smoked chicken breast (Thanks Ezra!), I made a smoked chicken and cheese wrap.   Chunks of smoked chicken and chunks of Boar’s Head Munster cheese into a cast iron skillet until sizzling.  Flour tortilla into another skillet with a dollop of butter until browned on both sides.  A little bit of mustard and mayonnaise wrapped up with the sizzling chicken and cheese mix…. it was divine.

20180319_232019.jpg

 

 

by

Beef and Broccoli v2

This is our second go at beef and broccoli (with peppers, sugar snap peas, and carrots).

For the first try see: https://blog.gahooa.com/2018/03/12/beef-and-broccoli-recipe/

  • Beef was cut a bit smaller.
  • Soaked 4 cups water + 1/4 cup baking soda + 1 tbsp salt for 13 minutes.
  • Veggies were boiled slightly less – they were not quite done when we drained them.  This way when mixed and heated again with the meat and sauce they ended up about perfect.

Also first try at fried rice.  I thought for sure I ruined it but it turned out okay.  Looking forward to doing this again.

20180315_192328.jpg

20180315_192349.jpg

by

Baked Mac ‘n Cheese

So the other day we cooked up a couple of pounds of macaroni, strained it, and added a little bit of butter to keep it from sticking together.  Then into a pot with milk, several bags of shredded cheese, some bbq seasoning, salt, pepper, and a can of cream of celery soup.  Then it got baked for about an hour with cheese and breadcrumbs sprinkled on top.

It was pretty good.  Not bad at all, but not amazing.

Leftovers went in fridge.  A couple of days later, I needed a quick dinner for some of the kids, so I threw some of the leftovers in a well seasoned cast iron skillet and heated it up on high heat until it was nicely sizzled.

Best.Mac.And.Cheese.Ever.Period

In my whole life I never had better mac ‘n cheese.  I’m not sure exactly what made it the best, but here is a picture, and we’re going to have to try this again sometime.

20180312_204027.jpg

 

by

Beef and Broccoli (Recipe)

This is my first go at Beef and Broccoli.  While it’s not quite as “pretty” as the chicken dishes, it’s flavor and texture was outstanding.

I like doing this at home, from scratch, because it is a challenge, and lets me cook quite healthy food that tastes amazing.

Ingredients:

  • Stir fry beef (1+ lb)
  • 2 big broccoli crowns (2+ lbs)
  • half a bag of sliced carrots (about 1/2 lb)
  • a large green pepper
  • kikkoman hoisin sauce (half jar – about 5 oz)
  • sesame oil (about 1-2 tsp)
  • peanut oil (about 4 tbsp)
  • fresh garlic (5-10 cloves, less than one head)
  • ground ginger (about 1 tsp)
  • kikkoman reduced sodium soy sauce (a couple tbsp)
  • baking soda (1/4 cup or 4tbsp)

Prepare Rice

Put 1-2 cups of rice in your largest pot full of boiling water.  Keep on high.  After 13 minutes, dump in strainer and rinse with warm water to stop it from cooking.  Remove to bowl and wash your strainer :)

Prepare Meat

Trim meat down into consistently sized pieces.  Most of what I had was about 1/2″ wide by 1/4″ to 3/8″ thick.

Place in large bowl along with 4 cups warm water and 4 tbsp baking soda.  Agitate every couple of minutes to keep the baking soda from settling out.  After 10-12 minutes, place in strainer and rinse with cool/warm water, then after done dripping, move to a bowl and wash your strainer :)

Note: do not leave it in solution too long or it will start to gain a weird texture that is not appetizing.  If left in just the right amount of time it will have a soft texture like from a restaurant.

Once in the bowl, crush 5-10 cloves of garlic on the meat.  Sprinkle a generous amount of ginger on it as well (1 tsp).  Put 5-10 shakes of sesame oil on it as well (1 tsp).

Prepare Veggies

While meat is soaking, chop up pepper, carrots, brocolli into bite sized pieces.  Place in large bowl.

Get a large pot full of boiling water and dump the vegetables in.  Keep on high heat.  It only takes 3-5 minutes, you’ll know they are done by sampling them to see when they are soft but still crispy. Without delay, dump into strainer to stop them from cooking in the hot water.  Remove to bowl and wash your strainer :)

Cook Meat:

In your largest skillet, hopefully cast iron, and on super high heat (I use 2 burners with a 17″ skillet), get the skillet smoking hot.  Then add about 4 tbsp of peanut oil.  Promptly dump in the meat and then start and keep moving it around.  You want the skillet to stay hot hot hot.  When you think it is about done, snip a thick piece in half to see if it is cooked through.  Try not to over cook as this only takes about 3-5 minutes.

Once done keep heat on medium high and:

Assemble It:

Dump in veggies.  All of the veggies.  Dump in half a jar of hoisin sauce (about 4-5 oz).  Add a generous amount (1-2 tbsp) of soy sauce.  All this time you should be stirring so as to sizzle the veggies, but not too long, maybe 45 seconds or so.

Turn off heat.  Make sure it is all stirred together and if needed add a little more soy sauce, ginger, sesame oil, salt, or hoisin sauce – all to taste.

Enjoy:

Compared to many restaurant versions that are heavy on the sauce, this is a “light dish”,. It only has about 5 tbsp of oil covering 10 generous servings.  And the fact that 1 lb of meat is spread across 10 servings means it is mostly veggies.

We put down about 1/2 rice and cover it with about 1/2 beef and broccoli.

20180312_130240.jpg

Note: this is a “draft recipe” from memory based on my first experience with cooking this dish.  But it did turn out well I thought I’d write it down.  I did not base this on another recipe, but rather from some techniques I’ve been practicing.

 

 

by

Python Word Find Program

Ezra and I took 30 minutes this evening and wrote a word find puzzle solver in Python.  This uses a little bit of pre-processing, sets, dictionaries, tuples, and other (less efficient) techniques to fairly quickly find the answers.


board = '''
m a i n v f
a n a f d d
s m i t h a
i r o n r v
e m o z a i
a e e t a d
'''
words = '''
ezra
david
sam
smith
iron
fire
'''
# use this to get a dictionary involved.
#words = open('dictionary.txt', 'rt').read()
BOARD = {}
x = 0
y = 0
for line in board.strip().split('\n'):
y += 1
x = 0
for char in line:
char = char.lower()
if char in 'abcdefghijklmnopqrstuvwxyz':
x += 1
BOARD[x,y] = char
WORDS = set()
for line in words.strip().split('\n'):
word = line.strip().lower()
if len(word) >= 3:
WORDS.add(word)
DIREC = (
(0,-1),
(1,-1),
(1,0),
(1,1),
(0,1),
(-1,1),
(-1,0),
(-1,-1),
)
PREFX = set()
FOUND = set()
for word in WORDS:
prefix = ''
for c in word[:-1]:
prefix += c
PREFX.add(prefix)
# For each position on the board
for x,y in BOARD:
# For each direction of 8
for xx,yy in DIREC:
x1 = x #cur pos
y1 = y #cur pos
word = '' #cur word
while True:
# Check if off board
if (x1,y1) not in BOARD:
break
# Get character at current pos
word += BOARD[x1,y1]
# If it is a word, add it
if word in WORDS:
FOUND.add(word)
# If this is not a prefix, then bail out
if word not in PREFX:
break
# Increment current position based on direction
x1 += xx
y1 += yy
print(FOUND)

view raw

wordfind.py

hosted with ❤ by GitHub